Researchers in China have investigated how screen printing damages copper-plated silicon heterojunction (HJT) solar cells and have proposed a modified screen design to reduce the effect. The work focuses on the photoresist-printing step used in copper metallization, where the screen can contact the wafer directly and wear over repeated cycles.
HJT cells rely on sensitive passivating contact structures. Mechanical pressure and thermal treatments during screen printing can damage these layers, raising recombination losses and lowering conversion efficiency. Copper plating is attractive because it can reduce metallization costs and silver use, making process reliability important for large-scale manufacturing.
A different printing contact
Corresponding author Lang Zhou said photoresist printing differs fundamentally from conventional silver-paste printing. In silver paste screens, openings cover only 2–5% of the total area, and an emulsion layer over the rest prevents the mesh from touching the wafer. Full-area photoresist coating typically uses a screen without emulsion coverage to ensure uniform resist deposition. As a result, the mesh comes into direct and extensive contact with the wafer during every printing cycle.
Earlier investigations cited by the team showed conversion efficiency falling from 26.2% to 25.7% over 15,000 consecutive printing cycles in commercial solar cell production. Open-circuit voltage and fill factor accounted for most of the loss, while short-circuit current density and electrical resistance remained largely unchanged. Minority carrier lifetime degradation rose from 0.61% with a new screen to 11.0% after 15,000 cycles.
Knuckle wear and interface damage
Using three-dimensional confocal microscopy, the researchers identified progressive wear of the screen mesh knuckles as the main cause. As the knuckles wore down, their contact area with the wafer increased, placing greater mechanical stress on the underlying passivation layers. Scanning electron microscopy showed no visible surface scratches, but photoluminescence measurements confirmed higher recombination losses. The team says this points to damage at the amorphous silicon/crystalline silicon interface.
Emulsion buffer and trade-off
To prevent direct contact between the mesh and the wafer, the researchers developed an emulsion buffer layer and evaluated six patterns with emulsion coverage ratios from 2.9% to 16.6%. Higher coverage provided more mechanical protection but impaired photoresist coating uniformity, creating a trade-off between damage reduction and ink distribution.
A 4.7% emulsion coverage ratio gave the best balance in their tests. It limited minority carrier lifetime degradation to 0.41% after 10,000 printing cycles while maintaining relatively good coating uniformity. The researchers attribute the improvement to the emulsion layer keeping the mesh away from the wafer surface and thereby reducing cumulative mechanical damage to the passivation layers.
Zhou said the findings show that a relatively simple screen-design change can substantially mitigate printing-induced degradation and offer a practical route to improving manufacturing reliability for copper-plated HJT cells. The team published its results in Solar Energy, in a paper titled “Screen-printing photoresist induced efficiency degradation and mitigation in Cu-plated SHJ solar cells.”
Broader copper-metallization push
The work comes as copper metallization draws growing interest as an alternative to silver contacts in HJT cells. In April 2026, researchers at China’s Nankai University reported a silver-free HJT cell with 25.2% efficiency, using plasma-induced interface engineering and copper electroplating. That approach addressed adhesion, contact resistance and stability challenges at the indium tin oxide interface.
Separately, scientists at Germany’s Forschungszentrum Jülich achieved 23.08% efficiency in a fully copper-metallized HJT cell. The silver-free device had a relatively small efficiency penalty compared with its silver-metallized counterpart, while cells combining silver-copper paste on the front and silver contacts on the rear reached 23.95%. Those results highlight copper’s potential to cut silver consumption, though further improvements in processing and electrical performance are still needed.
